A618 Transmission parts, repair guidelines, problems, manuals

47RH, 47RE, 48RE

Transmission general data

Number of gears Transmission Type Drive Torque (Nm) ATF (full capacity) L ATF (change) L ATF type
4 AT RWD 610 13,4 4,8 Mopar ATF+4

The family of 4-speed automatic transmissions "TorqueFlite" - A518 / A618, has been mainly installed on the rear-wheel drive trucks and vans produced by Dodge and Jeep since 1990. The A518 was modified to 46RH (retainer hydraulic) and later to 46RE (retainer electronic), while A618 was updated to 47RE and 48RE. The A618 transmission is considered to be a heavier-duty modification of A518. The driving torque of the A618 transmission is equal to 610 Nm.

What are you looking for?

Overhaul Kit | Friction Kit | Friction | Steel Plate | Steel Kit | Band | Solenoid Kit | Solenoid EPC | Solenoid TCC | Pump | Shaft | Drum | Valve body | Torque converter | Hub | Piston | Piston Kit | Planetary Gear | Filter | Gasket | Bushing | Seal | Bearing | Pressure Plate | Stator | Differential | Retainer | Inhibitor Switch | Instruction manual | TOOLS & ACCESORIES | Sensor

Price on request
A618, Clutch

Price on request
A618, Governor

Price on request
A618, Overhaul Kit

Price on request
A618, Overdrive

Price on request
A618, Friction

Price on request
A618, Filter

Price on request
A618, Torque converter

Price on request
A618, Solenoid EPC

Price on request
A618, Band

Price on request
A618, misc

Price on request
A618, Solenoid

Price on request
A618, Friction Kit

Price on request
A618, Sensor

Price on request
A618, Gasket

Price on request
A618, Valve body

Price on request
A618, Drum

Price on request
A618, Electrical

Price on request
A618, Pressure Sensor

Price on request
A618, Spring

Price on request
A618, Bushing

The design of the A518/A618 and 46RH / 46RE / 47RH / 47RE / 48RE transmissions is based on the same principle. All differences and modifications consist in the increased number of gears and addition of the torque converter and the block of solenoids.

Typical problems

Transmissions of this family were used by car manufacturers for three decades thanks to their easy maintenance and resistance to wear. Not complicated assembly of these transmissions simplifies their repair process. Early transmissions of this family rarely require any repair. The problem of spare parts replacement occurs in cars equipped with transmissions, which have solenoids and the valve body. These transmission components get out of order when the car mileage reaches 100 thousand kilometers. Such breakdowns result in expansive repair services, because damaged components should be replaced.

The most problematic areas in A518/A618:

- Central Support

- Retained (Governor) is usually rebuilt

- Direct Drum – exhausts its resource, but more often this component burns out because of a long-time operation with insufficient linear pressure

- Reverse Drum

- Frictional wheel-hub. Direct.

- The set of solenoids and sensors

Other seals, bushings, springs and bearings fail to function occasionally, due to peculiarities of the driving style and operation.