TF80SC Transpeed Transmission parts, repair guidelines, problems, manuals
Transmission general data
| Number of gears | Transmission Type | Drive | Torque (Nm) | ATF (full capacity) L | ATF (change) L | ATF type |
|---|---|---|---|---|---|---|
| 6 | AT | FWD/AWD | 450 | 7 | 3,8 | Type T-IV |
What are you looking for?
Overhaul Kit | Friction Kit | Friction | Steel Plate | Steel Kit | Band | Solenoid Kit | Solenoid EPC | Solenoid TCC | Pump | Shaft | Drum | Valve body | Torque converter | Hub | Piston | Piston Kit | Planetary Gear | Filter | Gasket | Bushing | Seal | Bearing | Pressure Plate | Stator | Differential | Retainer | Inhibitor Switch | Instruction manual | TOOLS & ACCESORIES | Sensor
Whoops! Looks like we don't have any offers for this part. But don't get upset, you can place a buying lead for this part in our Transmission Parts Bulletin Board, and sellers will contact you directly.
Technical issues and repair guidelines
The torque converter intensively contaminates the ATF with dust from carbon friction lining. Almost each transmission repair includes cutting of the torque converter and replacement of the friction lining. The worn-out friction lining of the torque converter has a negative impact on the valve body. The more aggressively the driver pushes on the gas pedal, the earlier the computer switches on the slipping mode of the torque converter friction, resulting in rapid wear-out of friction plates and the necessity to rebuild the the torque converter and the valve body. This transmission is sensitive not only to contaminated oil, but also to the wear-out of teflon rings (where oil leakages may occur). The operation with worn-out spare parts leads to burning of frictions, and later to problems with solenoids and the valve body.
The whole kit of friction discs is replaced in case of burnt oil. The package С2 (4-5-6) is usually the first to burn (in some cases it may be the package 1-2-3-4 Clutch (C1)). The standard kit for reassembly includes the kit of pistons. (С2 piston+retainer, retainers С1 and С3). The kit includes the most popular pistons ordered by transmission specialists. In case of burnt ATF, it is also recommended to replace the Reverse brake band , because its friction lining is affected by burnt ATF. The problem of frictions burning are usually related to the wear-out of teflon rings.
The pump bushing turns out to be the most vulnerable part in the TF80 transmission, in case of the torque converter parts wearout. Problems may also occur in the differential (in AWD Mazda CX7, CX9). The problem lies in the spline failure. This issue is caused by the ECU settings, allowing overloading.
Generally, the TF-80SC transmission is extremely reliable and successful 6-speed unit, which causes less problems in comparison with its predecessors TF60SN and AW55-50. It may be considered as an “invincible” solution and the most maintenance-friendly 6-speed automatic transmission.