4EAT Instruction manual Transmission parts
Transmission general data
|Number of gears||Transmission Type||Drive||Torque (Nm)||ATF (full capacity) L||ATF (change) L||ATF type (recommended)|
|4||AT||FWD||300||9,5||6||Dexron III-VI / Mercon V|
What are you looking for?
Overhaul Kit | Friction Kit | Friction | Steel Plate | Steel Kit | Band | Solenoid Kit | Solenoid EPC | Solenoid TCC | Pump | Shaft | Drum | Valve body | Torque converter | Hub | Piston | Piston Kit | Planetary Gear | Filter | Gasket | Bushing | Seal | Bearing | Pressure Plate | Stator | Differential | Retainer | Inhibitor Switch | Instruction manual | TOOLS & ACCESORIES | Sensor
Technical issues and repair guidelines
Subaru vehicles with this transmission rarely come to transmission repair shops. In terms of maintenance services, this transmission is very similar to Jatco transmnissions. The 4EAT unit is a very reliable and simple system with special settings which do not allow drivers to overload prone-to-damage parts with a high degree of safety.
Overhauls usually consist of the reassembly procedure with replacement of the filter and repair kit of gaskets and seals. A kit of friction components is also commonly ordered by transmission specialists together with the abovementioned components. If the transmission operates for a long time with burnt fluid, then all steel discs get replaced with frictions. The external filter protects the valve body and solenoids from contaminated ATF, which appears because of the worn friction lining of the torque converter. Specialists recommend to replace it together with the engine oil filter on cars where the mileage parameter enxceeds 100 thousand kilometers, especially after a hot summer. The valve body unit of this transmission was updated in 1998 (type 2) and in 2001. These components are quite durable and require only timely cleaning.
If the transmission is overheated and has leakages through the pump seal of the torque converter and oil rapidly gets contaminated after the ATF, then the torque converter lock-up clutch is likely to wear out, and as a result damages the wheel hub. The torque converter is repaired and the valve body gets cleaned from the dirt, which appears from the damaged friction, and the overhaul kit is replaced. The first standard overhaul of the car with high mileage always includes replacement of pistons with frictions and a solenoid of linear pressure. The resource of this transmission is above the average and after a proper overhaul may be increased for several years.